Canon REALiS LCOS SX80 Mark II Multimedia Projector SX80 MarkII/SX800 Users Ma - Page 146
Replacing the Lamp, As shown in the replace
View all Canon REALiS LCOS SX80 Mark II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
Maintenance ■Replacing the Lamp 1 Turn off the projector, disconnect the power plug from the AC outlet, and let the projector stand for at least 1 hour. 2 As shown in the figure, insert a flat- head screwdriver in the gap and remove the lamp cover by raising it. 3 Loosen two screws with a phillips- head screwdriver and then pull up the handle. * Pull up the handle as shown in the figure. 4 Remove the lamp while holding the center of the handle. 5 Fully insert a new lamp and secure it with two screws. * After the installation, be sure to push down the handle. 6 As shown in the figure, replace the lamp cover. Check whether the lamp cover is installed securely. 7 Turn on the projector. 8 Bring up the menu and select [System settings] -> [Other settings] -> [Lamp counter]. (P109) 9 Select [Reset] -> [OK] to reset the lamp counter. 146