Canon REALiS LCOS SX80 Mark II Multimedia Projector SX80 MarkII/SX800 Users Ma - Page 55
Selecting an Input Signal, In SX80 MarkII, [HDMI], [DIGITAL PC], and [ANALOG PC-1] may be displayed
View all Canon REALiS LCOS SX80 Mark II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Projecting an Image < Selecting an Input Signal (INPUT) ■Selecting an Input Signal 1 Press the INPUT button to pop up a window shown at the lower right. Remote control Top control SX80 MarkII SX800 The currently active input signal is marked with a circle and highlighted in orange. An input signal that is ready for projection is displayed in white. When no signal is received, it is displayed in gray. In SX80 MarkII, [HDMI], [DIGITAL PC], and [ANALOG PC-1] may be displayed in gray even if they are ready for projection. When you select [USB] with no PictBridge enabled equipment or an USB flash memory connected and pressing the OK button, a window waiting for you to connect a PictBridge enabled equipment or an USB flash memory appears. For more details, refer to "Projecting an Image from a Digital Camera (SX80 II)" (P114 - P117) or "Projecting Data on USB Flash Memory (SX80 II)" (P118 - P124). 2 The selection is toggled through available input signal types by pressing the INPUT button. • You can select the target input signal with Only the input signals displayed in white can be selected. 3 Press the OK button to determine the input signal type. If no button is pressed in 4 seconds, the selected input signal type is chosen. < 55