Canon Vb-C60 Network Video Recorder VK-64/VK-16 Administrator's Manual - Page 273

Error Codes in Log File Messages List Winsock Error Codes Codes 10038 10048 10050 10051 10054 10060 10061 10064 10065 Error Messages An operation was attempted on something that is not a socket. Only one usage of each socket address (protocol/network address/port) is normally permitted. A socket operation encountered a dead network. A socket operation was attempted to an unreachable network. An existing connection was forcibly closed by the remote host. A connection attempt failed because the connected party did not properly respond after a period of time, or established connection failed because connected host has failed to respond. No connection could be made because the target machine actively refused it. A socket operation failed because the destination host was down. A socket operation was attempted to an unreachable host. Description This may be recorded in Version 1.1, however, there is no necessary action. All resources for communication are being used. This frequently occurs when a black screen problem occurs in Viewer layout sequences. This occurs when the PC recognizes that the network is not available because the closest router or Hub to the PC is powered off. Normally, this cannot be recognized, therefore it is rare that this error is reported. This occurs when another network device recognizes that the network is not available because the router or Hub is powered off. Normally, this cannot be recognized, therefore it is rare that this error is reported. The connection is disconnected by the camera server due to camera server restart or other cause. This may occur when the camera server is restarted using the restart button on the configuration page on the software-side. However, this rarely occurs. A timeout occurred in the TCP connection with the camera server (This occurs when the camera server is down). The camera server rejected the TCP connection (This occurs when the port number specification is incorrect or other cause). This is recorded when the camera server is down (Normally, 10060 occurs). There are no routes to connect to the camera server (This may also occur when there is a failure in the network cable connected to the PC or HUB). Troubleshooting 9-31