Canon XA25 Instruction Manual - Page 165
List of Messages for Wi-Fi Functions
View all Canon XA25 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 165 highlights
Troubleshooting To record video on this memory card, it is recommended to use a video quality setting other than [59.94P Recording]. - When using a memory card rated SD Speed Class 2 or 4, you may not be able to record movies if you use a recording mode of 28 Mbps LPCM (59.94P), 28 Mbps (59.94P) or 35 Mbps (59.94P). To use this function change the camera mode to Manual or Cinema - C, the CUSTOM dial (A 96) and some of the functions that can be assigned to the assignable buttons (A 97) cannot be used in mode. Set the mode switch to n ( mode) or E( mode) to use them. Too many photos and MP4 movies. Disconnect the USB cable. - Disconnect the USB cable. Try using a memory card reader or decrease the number of photos and MP4 movies on the memory card to fewer than 2,500 (Windows), or 1,000 (Mac OS). - If a dialog box appeared on the computer screen, close it. Disconnect the USB cable, and restore the connection after a short while. Unable to recognize the data - The camcorder cannot recognize data that was recorded using a video configuration that is not supported (PAL or SECAM). Unable to recover data - Could not recover a corrupted file. Save your recordings (A 114) and initialize the memory card using the [Complete Initialization] option (A 38). 165 List of Messages for Wi-Fi Functions Refer also to the instruction manual of your access point and other devices you will use. Another user is already controlling the camcorder. Try again later. - This message appears on the screen of the Wi-Fi device. Multiple Wi-Fi devices are trying to connect with the camcorder. Make sure only one Wi-Fi device is trying to connect and then touch Retry. IP address conflict - Change the camcorder's IP address to avoid any conflict with devices connected to the same network. Alternatively, change the IP address of the conflicting device. Memory card cover is open - The double memory card slot cover was opened while the memory card was being accessed. Stop the Wi-Fi function in use and end the Wi-Fi connection. Multiple access points detected. Try the operation again. - There are multiple access points sending out a WPS signal at the same time. Try the operation again later or perform setup using the [WPS: PIN Code] or [Search for Access Points] option (A 137). No access points found - The access point set in the camcorder could not be found. - Cordless phones, microwave ovens, refrigerators and other appliances may interfere with the wireless signal. Try using the camcorder in a location farther away from such appliances. - Make sure that you use the access point's SSID for the camcorder's Wi-Fi settings (A 138). - If the access point is using MAC address filtering, enter the camcorder's MAC address in the access point's configuration screen. Unable to access configuration files - Turn off the camcorder. After a short while, turn it on again. If the problem persists contact a Canon Service Center.