Casio KL 780 User Guide - Page 24
Error Messages/Display Messages - data error
UPC - 079767163716
View all Casio KL 780 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Ink ribbon is being fed from the tape outlet along with the tape. Possible Causes Action Page Tape cartridge loaded while the ink ribbon is slack. Remove the tape cartridge and check to make sure the ink ribbon is not broken. Next, take up any slack in the ink ribbon and then reload the tape cartridge. Important! • Before loading a tape cartridge into E-8 the label printer, always make sure you take up any slack in the ink ribbon first. • If the ink ribbon is broken, you must change to another tape cartridge. • Tape Cutting Cannot cut tape. Possible Causes Action Tape cutter blade is dull. Take the label printer to the dealer from whom you purchased it to have the tape cutter blade replaced. Printed text is cut off by tape cut operation. Possible Causes Action Out of tape Replace the tape cartridge with a new one. Page - Page E-8 • Using Labels Label will not adhere to a surface. Possible Causes Action The backing paper is still Peel the backing paper from the back on the back of the tape. of the tape to expose the adhesive. Surface is unsuitable for affixing a tape. Labels do not adhere well to surfaces that are rough, wet, oily, or dirty. Page E-16 E-16 Error Messages/Display Messages Message Possible Causes Action ¥ ERROR! * This message appears on the screen for about one second. • The number carriage returns you input causes the label to exceed the maximum number of lines for the tape you are using. • You are attempting to print a stamp while three lines of text are input. • Use wider tape or reduce the number of lines. 6mm tape...1 line 9mm tape...1 line 12mm tape...Up to 2 lines 18mm tape...Up to 3 lines • Reduce the number of lines of text to two. NO DATA! * This message appears on the screen for about one second. • You are attempting to recall text from memory when there is none stored. OVERWRITE? SET/ESC • You are attempting to store text in memory when it already containes text. • Press SET to overwrite the existing text with the new text, or ESC to cancel the store operation. E-23