Cisco 7008P Installation Guide - Page 10

Installing the Cisco SFS 7008P Switch into a Rack Figure 8 Management I/O Modules Located in the Back of the Unit Chassis ID Management I.O modules Power plug 1 Power plug 2 4x copper line interface modules Main air exhaust 144988 Configuring and Connecting Host Channel Expansion Card for IBM BladeCenter This section briefly describes configuring your InfiniBand host. Download the configuration software and an integrated suite of drivers including IPoIB, SRP, SDP, uDAPL and MPI from the Cisco Software Center at this URL: http://www.cisco.com/public/sw-center Install the Host Channel Expansion Card for IBM BladeCenter by doing the following: Step 1 Step 2 Step 3 Power down the host system following proper grounding procedures. Unpack the HCA module and insert it into an open 64-bit PCI or PCI-X slot. Power on the host system. Installing Host Channel Expansion Card Linux Drivers Make sure your Linux kernel is supported. See www.cisco.com for a list of supported versions. Cisco SFS 7008P InfiniBand Server Switch Installation and Configuration Note 10 78-17434-01 Rev. A0