Cisco AIR-RM1252G-A-K9= Hardware Installation Guide - Page 96
CDP_PD-4-POWER_OK: Full Power - INJECTOR_CON D_ON_SOURCE inline power
UPC - 882658140860
View all Cisco AIR-RM1252G-A-K9= manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Low Power Condition for Lightweight Access Points Chapter 4 Troubleshooting 1250 Series Lightweight Access Points When the access point determines that sufficient power is not available for full power operation, an error message is logged and the Status LED turns amber to indicate low power mode (see the "Checking the Lightweight Access Point LEDs" section on page 4-3 and the "Inline Power Status Messages" section on page 4-8). Tip If your switch is capable of supplying sufficient power for full operation but the access point remains in low-power mode, your access point or your switch (or both) might be misconfigured (see Table 4-3). For full power operation with both radio modules installed, the access point can only be powered by these options: • Use the 1250 series power injector (AIR-PWRINJ4) on the switch port • Use the 1250 series DC power module (AIR-PWR-SPLY1) to locally power the access point For full power operation with only one radio module installed, the access point can be powered by these options: • Use the 1250 series power injector (AIR-PWRINJ4) on the switch port • Use the 1250 series DC power module (AIR-PWR-SPLY1) to locally power the access point • Use an 802.3af power source Inline Power Status Messages These messages are logged on the console port by the access point to report the power condition: • %CDP_PD-4-POWER_OK: Full Power - AC_ADAPTOR inline power source-This message indicates the access point is using the power module and can support full-power operation with two radio modules. • %CDP_PD-4-POWER_OK: Full Power - NEGOTIATED inline power source-This message indicates the access point is operating at full power and has successfully negotiated for 15.4 W of power from a Cisco switch supporting Cisco Intelligent Power Management. • %CDP_PD-4-POWER_OK: Full Power - HIGH_POWER_CLASSIC inline power source-This message indicates the access point is operating at full power because it has been configured for pre-standard compatibility mode and has detected a Cisco switch that does not support Intelligent Power Management but is able to supply sufficient power to the access point. • %CDP_PD-4-POWER_OK: Full Power - INJECTOR_CONFIGURED_ON_SOURCE inline power source-This message indicates the access point is operating at full power because it is connected to a Cisco switch that supports Intelligent Power Management and the switch has been configured with the power inline never command. • %CDP_PD-4-POWER_OK: Full power - INJECTOR_CONFIGURED_ON_CURRENT_PORT inline power source-This message indicates the access point is operating at full power because it has been configured to expect a power injector on this port. • %CDP_PD-4-POWER_OK: Full Power - INJECTOR_DETECTED_PD inline power source-This message indicates the access point is operating at full power because it has detected a CDP packet from another Cisco powerable device (PD). The access point power is being supplied from a power injector or a non-Cisco power source because a Cisco power source does not transmit this type of CDP packet. Cisco Aironet 1250 Series Access Point Hardware Installation Guide 4-8 OL-8247-03