Cisco ASR1002 Configuration Guide - Page 41

Using Cisco IOS XE Software Using the no and default Forms of Commands Table 9 Finding Command Options (continued) Command Router(config-if)# ip address ? A.B.C.D IP address negotiated IP Address negotiated over PPP Router(config-if)# ip address Router(config-if)# ip address 172.16.0.1 ? A.B.C.D IP subnet mask Router(config-if)# ip address 172.16.0.1 Router(config-if)# ip address 172.16.0.1 255.255.255.0 ? secondary Make this IP address a secondary address Router(config-if)# ip address 172.16.0.1 255.255.255.0 Router(config-if)# ip address 172.16.0.1 255.255.255.0 Router(config-if)# Comment Enter the command that you want to configure for the interface. This example uses the ip address command. Enter ? to display what you must enter next on the command line. In this example, you must enter an IP address or the negotiated keyword. A carriage return () is not displayed; therefore, you must enter additional keywords or arguments to complete the command. Enter the keyword or argument that you want to use. This example uses the 172.16.0.1 IP address. Enter ? to display what you must enter next on the command line. In this example, you must enter an IP subnet mask. A is not displayed; therefore, you must enter additional keywords or arguments to complete the command. Enter the IP subnet mask. This example uses the 255.255.255.0 IP subnet mask. Enter ? to display what you must enter next on the command line. In this example, you can enter the secondary keyword, or you can press Enter. A is displayed; you can press Enter to complete the command, or you can enter another keyword. In this example, Enter is pressed to complete the command. Using the no and default Forms of Commands Almost every configuration command has a no form. In general, use the no form to disable a function. Use the command without the no keyword to re-enable a disabled function or to enable a function that is disabled by default. For example, IP routing is enabled by default. To disable IP routing, use the no ip routing command; to re-enable IP routing, use the ip routing command. The Cisco IOS software command reference publications provide the complete syntax for the configuration commands and describe what the no form of a command does. Many CLI commands also have a default form. By issuing the command default command-name, you can configure the command to its default setting. The Cisco IOS software command reference publications describe the function of the default form of the command when the default form performs a different function than the plain and no forms of the command. To see what default commands are available on your system, enter default ? in the appropriate command mode. Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide 11