Cisco CP-7914 Quick Start Guide - Page 6

Installing the 7914 Expansion Module Note To ensure a successful installation of the 7914 Expansion Module, make sure you have read the entire "Before You Begin" section on page 3. To install the 7914 Expansion Module, you need to perform the following steps. 1. Remove the Footstand from the Cisco IP Phone 7960 2. Connect the Support Bar to the Cisco IP Phone 7960 3. Connect the 7914 Expansion Module to the Support Bar 4. Connect the RS 232 Cable 5. Connect the Power Supply 6. Connect the Footstand Refer to the detailed instructions and corresponding illustrations that follow for each of these high-level steps. Caution To ensure a successful installation, verify with your system administrator that your phone is ready for the 7914 Expansion Module and that Cisco CallManager is installed and configured for the 7914 Expansion Module. See the Cisco IP Phone Administration Guide for Cisco CallManager for more information. Make sure that you have all of the parts that you need (see the "Before You Begin" section on page 3). 1. Remove the Footstand from the Cisco IP Phone 7960 To remove the footstand from the IP Phone 7960 to which you are attaching the 7914 Expansion Module, follow these steps. Step 1 Unplug the Cisco IP Phone 7960 network and power connections. 6