Cisco MWR-1941-DC-2T1 Hardware Installation Guide - Page 25
Environmental Monitoring Temperature Sensor, System Specifications, Cisco MWR 1941-DC Router - mwr dc description
![]() |
View all Cisco MWR-1941-DC-2T1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Chapter 1 Overview of the Cisco MWR 1941-DC Router Environmental Monitoring Temperature Sensor Environmental Monitoring Temperature Sensor The MWR 1941-DC router has a temperature sensor to detect over-temperature conditions inside the chassis. The over-temperature detection trips at 75°C +/- 5%. This condition is reported to the processor as an interrupt and software then takes action on this interrupt to generate the appropriate alarming. If the router reaches a temperature of 90°C, the power supply will cycle to prevent the box from exceeding that temperature in a powered up state. System Specifications Table 1-4 lists the Cisco MWR 1941-DC router system specifications. Table 1-4 Cisco MWR 1941-DC Router System Specifications Description Specification Dimensions (H x W x D) 1.72 x 17.5 x 12.5 in. (4.368 x 44.45 x 31.75 cm) 1RU/19.00 Rack Mount Weight 10.5 lb (4.77 kg) Console and Auxiliary ports Operating Temperature RJ-45 connector 32 to 122°F (0 to + 50°C)1 Non-Operational Temperature -40 to 185°F (-40 to 85°C) Operating Humidity 5 to 90% RH (non-condensing) Operating Altitude +3000m @ 113°F (45°C) Operating Vibration 0.41 Grms, 3 to 500 Hz/2 hours per axis GR-63-CORE earthquake resistance, Zone 4, shelf-level Non-Operational Vibration 1.12 Grms, 3 to 500 Hz/30 minutes per axis Operating Acoustics < 60 dBa 1. When two or less VWIC-2MFT-T1/E1-DIRs are installed in the Cisco MWR 1941-DC router, an operating temperature range of 14 to 131°F (-10 to +55°C) is supported. Cisco MWR 1941-DC Router Interface Numbering Each network interface on a Cisco MWR 1941-DC router is identified by a slot number and a port number. Figure 1-5 shows an example of interface numbering on a Cisco MWR 1941-DC router with the following configuration for a Cell Site DCN implementation: • A VWIC in two of the three VWIC slots • A 4-port asynchronous/synchronous serial network module in slot 1 • Two built-in Fast Ethernet interfaces 78-15827-06B0 Cisco MWR 1941-DC Mobile Wireless Edge Router Hardware Installation Guide 1-9
![](/manual_guide/products/cisco-mwr-1941dc-hardware-installation-guide-a37429e/25.png)