Cisco MWR-1941-DC-2T1 Hardware Installation Guide - Page 51
Step 1, Step 2, Step 3, Step 4, Step 5, Step 6, Step 7
![]() |
View all Cisco MWR-1941-DC-2T1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Chapter 3 Installing the Router Connecting the MWR 1941-DC Router to a DC-Input Power Supply Step 1 Step 2 Step 3 Remove the ground-lug screw from the rear panel of the router (shown in Figure 1-4 on page 1-4). Use a standard Phillips screwdriver or a ratcheting torque screwdriver with a Phillips head. Set the screw aside. If your ground wire is insulated, use a wire-stripping tool to strip the 10-AWG ground wire to 0.5 inch ± 0.02 inch (as shown below). 0.50" ± 0.02" 10358 Insulation Wire lead Step 4 Step 5 Slide the open end of your ground lug over the exposed area of the 10-AWG wire. Using a crimping tool (as specified by the ground lug manufacturer), crimp the ground lug to the 10-AWG wire (as shown below). 10360 Step 6 Step 7 Use the screw to attach the ground lug and wire assembly to the rear panel of the switch. Using a ratcheting torque screwdriver, torque the ground-lug screw to 15 1bf-in (or 240 ounce-force inches [240 ozf-in]). 78-15827-06B0 Cisco MWR 1941-DC Mobile Wireless Edge Router Hardware Installation Guide 3-11
![](/manual_guide/products/cisco-mwr-1941dc-hardware-installation-guide-a37429e/51.png)