Cisco MWR-1941-DC-2T1 Hardware Installation Guide - Page 27
Regulatory Compliance
![]() |
View all Cisco MWR-1941-DC-2T1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Chapter 1 Overview of the Cisco MWR 1941-DC Router Regulatory Compliance For example, if you have a VWIC in two of the VWIC slots (W0 and W1), then the interfaces are: - Serial 0/0 and Serial 0/1 in physical slot W0 - Serial 0/2 and Serial 0/3 in physical slot W1 However, if you install a VWIC in physical slot W1 (leaving slot W0 empty), the interfaces in slot W1 are Serial 0/0 and Serial 0/1. If you then add a VWIC to slot W0, the interface numbering will shift. The configuration that you created for interfaces Serial 0/0 and Serial 0/1 will now be applied to the VWIC in slot W0 and you will need to create a new configuration for the interfaces that you previously configured on W1 (which will now be Serial 0/2 and Serial 0/3). • The slot number of WIC/VWIC interfaces installed in slot 1 using a WAN network module is always 1 and the interfaces are always numbered from the right to left. • The slot number for all network module interfaces is always 1 and the interfaces are always numbered from right to left starting with 1/0. Regulatory Compliance For regulatory compliance and safety information, see the Regulatory Compliance and Safety Information for the Cisco MWR 1941-DC Mobile Wireless Edge Router document. This document shipped with your router and is also available on Cisco.com. See "Obtaining Documentation" section on page xi for more information. 78-15827-06B0 Cisco MWR 1941-DC Mobile Wireless Edge Router Hardware Installation Guide 1-11
![](/manual_guide/products/cisco-mwr-1941dc-hardware-installation-guide-a37429e/27.png)