Cisco MWR-1941-DC-2T1 Hardware Installation Guide - Page 43
Connecting the Console Terminal and Modem
View all Cisco MWR-1941-DC-2T1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Chapter 3 Installing the Router Figure 3-1 Attaching the Bracket Connecting the Console Terminal and Modem BEFORE INSTALLATION DSU 56K SEE MANUAL BEFORE INSTALLATION CONSOLE AUXILIARY 65785 Rack-mount bracket Installing the Router in the Rack Install the chassis in the rack. Rack-mounting screws are not provided with the router. Use three screws for each side (supplied with the rack). Connecting the Console Terminal and Modem This section describes how to connect a console terminal and a modem to the router. You can connect only a terminal to the console port. Use the auxiliary port with a terminal or a modem for remote access to the router. These ports provide administrative access to your router either locally (with a console terminal) or remotely (with a modem). Identifying a Rollover Cable Use a rollover cable to connect to the asynchronous serial console and auxiliary ports. You can identify a rollover cable by comparing the two modular ends of the cable. Holding the cables side-by-side, with the tab at the back, the wire connected to the pin on the outside of the left plug should be the same color as the wire connected to the pin on the outside of the right plug. (See Figure 3-2.) If your cable came from Cisco, pin 1 will be white on one connector, and pin 8 will be white on the other (a rollover cable reverses pins 1 and 8, 2 and 7, 3 and 6, and 4 and 5). 78-15827-06B0 Cisco MWR 1941-DC Mobile Wireless Edge Router Hardware Installation Guide 3-3