Cisco VG204 Software Configuration Guide - Page 17

Chapter 2 Using the setup Command Facility Configuring Global Parameters Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Cisco IOS Software, VG20X Software (VG20X-ADVIPSERVICESK9-M), Version 12.4(ORBITTY_APRIL18_POST_SYNC_BUILD.2008-04-17) UBUILDIT Image, CISCO DEVELOPMENT TEST VERSION Copyright (c) 1986-2008 by Cisco Systems, Inc. Compiled Fri 18-Apr-08 02:30 by geopasaaniha This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. Importers, exporters, distributors and users are responsible for compliance with U.S. and local country laws. By using this product you agree to comply with applicable laws and regulations. If you are unable to comply with U.S. and local laws, return this product immediately. A summary of U.S. laws governing Cisco cryptographic products may be found at: http://www.cisco.com/wwl/export/crypto/tool/stqrg.html If you require further assistance please contact us by sending email to [email protected]. Cisco VG202 (MPC8300) processor (revision 0x100) with 98304K/32768K bytes of memory. Processor board ID FOC11334C2B MPC8300 CPU Rev: Part Number 0x8062, Revision ID 0x11 2 FastEthernet interfaces 2 Voice FXS interfaces 256K bytes of non-volatile configuration memory. 126000K bytes of ATA CompactFlash (Read/Write) --- System Configuration Dialog --- Would you like to enter the initial configuration dialog? [yes/no]: y At any point you may enter a question mark '?' for help. Use ctrl-c to abort configuration dialog at any prompt. Default settings are in square brackets '[]'. Step 2 When the following message appears, enter yes to begin the initial configuration dialog: Would you like to enter the initial configuration dialog? [yes/no]: Step 3 When the following message appears, press Return to see the current interface summary: First, would you like to see the current interface summary? [yes]: Any interface listed with OK? value "NO" does not have a valid configuration Interface FastEthernet0/0 FastEthernet0/1 IP-Address unassigned unassigned OK? Method Status NO unset up NO unset up Protocol up down Step 4 Enter a hostname for the Cisco VG: OL-16191-01 Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide 2-3