Compaq 400338-001 HP J1473A 4-port, J1474A 8-port, J1475A Console Switch Rackm - Page 19

3 Basic Operations Keyboard Control The following notational conventions appear throughout this chapter to illustrate commands for operating the Rackmount Console Switch. Whenever you see one of the symbols listed on the left side of the table, substitute the corresponding steps or values listed on the right. Convention Key Sequence or Value Enter Command Mode: 1. Press and hold down the 'Num Lock' key. 2. Press and release the minus (-) key on the numeric keypad. 3. Release the 'Num Lock' key. Note: For alternate hot-key sequences, see 'System Control & Maintenance' later in this chapter. Press the 'Enter' or 'Return' key. The command is used to execute an instruction and exit from Command Mode. Addr The numbers on your Rackmount Console Switch are your servers' addresses. Enter the number for the server you're selecting. For cascaded systems, enter the port address on the base unit where the second switch is attached, then a period (.) followed by the address of the server in your cascaded unit. Example: A switch is cascaded from port 2 of your base unit. To access the server at port 3 of this second (cascaded) unit, enter 2.3. Press the 'Escape' key. The command is used to exit Command Mode without executing an instruction. Regarding OSD on-screen menu commands, the words 'choose' and 'select' indicate that a users should highlight the relevant command and press the enter key. www.hp.com/racksolutions 13