Compaq dc5850 Service Reference Guide: HP Compaq dc5850 Business PC - Page 152
USB connector on the system board labeled MEDIA., for an illustration of
View all Compaq dc5850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
3. Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward the front of the computer until it locks into place. 4. Connect the appropriate drive cables: a. If installing a diskette drive, connect the power and data cables to the rear of the drive and connect the other end of the data cable to the connector on the system board labeled FLOPPY. b. If installing a second hard drive, connect the power and data cables to the rear of the drive and connect the other end of the data cable to the next available (unpopulated) SATA connector on the system board in the following order: SATA0, SATA1, SATA5, SATA4. c. If installing a media card reader, connect the USB cable from the media card reader to the USB connector on the system board labeled MEDIA. NOTE: Refer to System Board Drive Connections on page 132 for an illustration of the system board drive connectors. 5. Replace the optical drive. 140 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis