Craftsman 28974 Operation Manual - Page 33
TROUBLESHOOTING, CHART, appropriate, in manual, unless, directed, to Sears, service, center
View all Craftsman 28974 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
_)N PARA LA ornpra. :stY.dise_ado do fiable por 3s productos, _nde tanto ,cuerdo de _edehacerles )tecciSn pare lest!as y gas- :juientes: 12,000 Ia reparaci6n. ]lguno pare 3bre todas las u producto glado. )recto corriente _tivas al Jerdo; tambi6n corriente de reventivo. soporte esentante iuieren un l programaci6n dentes. rdo, baste con ramar el servidie y noche o ;r el servicio. .-ialistas ue tienen partes y 1con que lar la vide del por muchos e Protecci6n y exclusiotenor m_s '-6655. NISEARS :ars de "aje0 _ortantes lamar a TROUBLESHOOTING CHART: See appropriate section in manual PROBLEM CAUSE unless directed to Sears service CORRECTION center Poor cut- uneven cutting Mower blades will not rotate Poor grass discharge 1 Worn, bent or loose blade. 2 Mower deck not level. 1 Replace blade. Tighten blade bolt 2 Level mower deck. 3 Buildup of grass, leaves, and trash under mower, 4 Bent blade mandrel. 5 Clogged mower deck vent from build-up of grass, leaves, and trash around mandrels. 1 Obstruction in clutch mechanism. 3 Clean underside of mower housing. 4 Contact a Sears or other qualified service center. 5 Clean around mandrels to open vent holes. 1 Remove obstruction. 2 Worntdamaged mower drive belt 2 Replace mower drive belt. 3 Frozen idler pulley. 4 Frozen blade mandrel. Engine speed too stow. 3 Replace idler pulley, 4 Contact a Sears or other qualified service center, 1 Place throttle control in "FAST" position. 2 Travelspeedtoo fast. 2 Shift to slower speed. 3 Wet grass. 4 Mower deck not level. 3 Allow grass to dry before mowing. 4 Level mower deck, Headlight(s) not working (if so equipped) Battery will not charge 5 Low/uneven tire air pressure. 6 Worn, bent or loose blade, 5 Check tires for proper PSI. 6 Replacefsharpen blade. Tighten blade bolt. 7 Buildup of grass, leaves and trash under mower. 8 Mower drive beltworn, 7 Clean underside of mower housing. 8 Replace mower drive belt. 9 Blades improperly installed. 9 Reinstall blades sharp edge down, 10 Improper blades used. 10 Replace with blades listed in this manua!. 1t Clogged mower deck vent holes 11 Clean around mandrels to from buildup of grass, leaves, and trash around mandrels, open vent holes. 1 Light Switch is "OFF", 1 Turn light switch "ON". 2 Bulb(s) or lamp(s) burned out, 2 Replace bulb(s) or lamp(s). 3 Faulty light switch. 3 Check/replace light switch. 4 Loose or damaged wiring. 4 Check wiring and connections, 5 Blown fuse. 5 Replace fuse. 1 Bad battery cell(s). 2 Poor cable connections. 1 Replace battery. 2 Check/clean allconnections. 3 Faulty regulator (if so equipped). 4 Faut[y alternator. 3 Replace regulator. 4 Replace alternator. 33