Craftsman 28974 Operation Manual - Page 9
Ntrol
View all Craftsman 28974 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
iCONTROLDE :)preajustado en ajustes. Revise _tinuaci6n, antes neoesario, yea )NTROL DE sido preajustado itar ajustes. kDOR do en la fa'brica _in embargo, se nor importancia _sen el combusSi el carburador de motor, INSTALL MOWER AND DRIVE BELT See MOWER AND DRIVE BELT ASSEMBEY Supplement Sheet for additional guidance on this assembly. Be sure tractor is on level surface and engage parking brake. 1. Lower attachment lift lever to it's lowest position. CAUTION: Lift lever is spring loaded. Have a tight grip on lift lever, lower it slowly and engage in lowest position. 2, Turn steering wheel to the left as far as it will go and position mower on right side of tractor with deflector shield to the right. - Pivot bar towards you and insert other end of bar into hole in rear mower bracket (D). Move mower as needed to insert bar. - Secure with washer and retainer spring as shown. 3. Remove plastic tie securing belt, bring belt forward and check belt for proper routing in all mower pulley grooves. ! 6. ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS- Position hole in arm over pin (B) on outside of tractor chassis and secure with washer and retainer spring. 7. Repeat on opposite side of tractor. NOTE: Be sure mower side suspension arms (A) are pointing forward before sliding mower under tractor. 4. Slide mower under tractor until it is centered under tractor. 5. FIRST INSTALL ANTI-SWAY BAR (S). - From right side of mower, insert ant-sway bar into hole in transmission bracket (T). 9