Cub Cadet CC 760ES CC 760ES Operator's Manual - Page 19
Tire Pressure, Cleaning the Mower - electrical parts
View all Cub Cadet CC 760ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Battery (Electric Start Models Only) 1. California Proposition 65 Warning! Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling. The battery is sealed and is maintenance-free. Acid levels cannot 2. be checked and fluid can not be added. • Always keep the battery cables and terminals clean and 3. free of corrosive build-up. • After cleaning the battery and terminals, apply a light coat of petroleum jelly or grease to both terminals. caution: If removing the battery for cleaning, disconnect the NEGATIVE (Black) wire from its terminal first, followed by the POSITIVE (Red) wire. When reinstalling the battery, always connect the POSITIVE (Red) wire its terminal first, followed by the NEGATIVE (Black) wire. Be certain that the wires are connected to the correct terminals; reversing them could result in serious damage to your engine's alternating system. Position the mower on a level, clear spot on your lawn, near enough for your garden hose to reach. caution: Make certain the mower's discharge chute is directed AWAY from your house, garage, parked cars, etc. Thread the hose coupler (packaged with your mower's Operator's Manual) onto the end of your garden hose. Attach the hose coupler to the water port on your deck's surface. See Fig. 6-3. Tire Pressure Warning! Warning! Under any circumstance do not exceed manufacturer's recommended psi. Equal tire pressure should be maintained at all times. Refer to sidewall of tire for recommended pressure. Periodically check the pressure on both your mower's rear tires. Uneven tire pressure will cause the cutting deck to mow unevenly and may result in mower to veering to either the left or right during operation. Refer to the tire side wall for tire manufacturer's recommended psi and deflate (or inflate) the tires as necessary. Cleaning the Mower Any fuel or oil spilled on the machine should be wiped off promptly. Do NOT allow debris to accumulate around the cooling fins of the engine, the transmission's cooling fan or on any other part of the machine, especially the belts and pulleys. Smart Jet Your mower's deck is equipped with a water port on its surface as part of its deck wash system. Use the Smart Jet to rinse grass clippings from the deck's underside and prevent the buildup of corrosive chemicals. Complete the following steps AFTER EACH MOWING: Warning! Before using the deck wash system, always disengage the Blade Control, stop engine and remove key to prevent unintended starting. Figure 6-3 4. Turn the water on. 5. Start the engine and place the throttle lever in the FAST (rabbit) position. 6. While in the operator's position behind the mower, move the Blade Control into the ON position. 7. Remain in the operator's position with the cutting deck engaged for a minimum of two minutes, allowing the underside of the cutting deck to thoroughly rinse. 8. Move the Blade Control into the OFF position. 9. Turn the ignition key (for electric start models) to the STOP position to turn the mower's engine off. 10. Turn the water off and detach the hose coupler from the water port on your deck's surface. After cleaning your deck with the Smart Jet system, start the mower's engine, return to the operator's position and engage the blades. Keep the cutting deck running for a minimum of two minutes, allowing the underside of the cutting deck to thoroughly dry. Section 6 - Maintenance & Adjustments 19