Cub Cadet ZTX4 60 Operation Manual - Page 11
Attaching the Seat Tether ZT6 Models Only, Adjusting the Seat, Adjusting the Mechanical Suspension
View all Cub Cadet ZTX4 60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ASSEMBLY Attaching the Seat Tether (ZT6 Models Only) ZT6 Models are shipped with the seat folded forward, and the seat tether cable detached from the seat pan. 1. Locate the seat tether cable. The lower end will be preinstalled on the inner left side of the frame. 2. Using a 7/16" wrench and a 3/8" wrench remove the shoulder bolt and hex lock nut from the left side of the seat pan. 3. Install the detached end of seat tether cable onto the seat pan with the hardware previously removed as shown in Figure 18: a. Slide the cable onto the shoulder bolt previously removed. b. Route the shoulder bolt through the hole from the inside outward. c. Secure the cable with the hex lock nut and torque to 68-102 in-lbs (8-11.5 N-m). Adjusting the Seat Figure 18 1. Push left and hold the seat adjustment lever to adjust the seat position. 2. Slide seat forward or rearward to desired position. 3. Release the adjustment lever. Ensure seat is locked into position before operation. See Figure 19. Figure 19 Adjusting the Mechanical Suspension Mechanism (ZT6 Models Only) The mechanical suspension mechanism (if equipped) incorporates weight/ride adjustment controls for operators in the 125 to 275 lb. (57-124 kg) weight range. Turn the knob on the front of the seat clockwise to increase the weight capacity and counter-clockwise to decrease. See Figure 20. Note: The seat base must be Figure 20 secured by the latch, otherwise, the seat assembly could tilt forward. The Operator Presence Sensor must be connected to the electrical wiring harness. 11