D-Link 1226G User Manual - Page 14

to reset the Gigabit port when transferring the media type Fiber to Copper or Copper to Fiber . - vlan

Get D-Link 1226G - DES Switch PDF manuals and user guides
UPC - 790069264221
View all D-Link 1226G manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Configuring Setup Setting There are four items, including Port Settings, VLAN Settings, Trunk Settings and Mirror Settings in Setup menu. Port Settings The Port Settings menu page (Figure 11) displays each port's status. Click on the ID parameter to set each port's Speed, Flow Control, QoS priority, and Link Status. When you need to renew the posted information, press the "Refresh" button. The Link Status in the screen will show the connection speed and duplex mode. This dialog box will display down when the port is disconnected. Figure 11. Port Configuration Note: 1. Be sure to reset the Gigabit port when transferring the media type ( Fiber to Copper or Copper to Fiber ). 2. The priority of Gigabit Fiber port is higher than Copper. To change the port setting, click on the ID parameter to enter the selected port to configure its Speed/Disable, Flow control, and QoS settings. Figure 12. Speed/Disable: This setting has six modes-100M Full, 100M Half, 10M Full, 10M Half, Auto, and Disable-for speed or port disable selections. Flow Control: This setting determines whether or not the Switch will be handling flow control. Set FlowCtrl to Enable to avoid data transfer overflow. It is set to Disable when there is either no flow control or other hardware/software management. When the port is set to forced mode, the flow control will automatically be set to Disable. QoS: 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
Configuring Setup Setting
There are four items, including
Port Settings, VLAN Settings, Trunk Settings and Mirror Settings
in Setup menu.
Port Settings
The Port Settings menu page (Figure 11) displays each port’s status. Click on the ID parameter to set each port’s
Speed, Flow Control, QoS priority,
and Link Status
. When you need to renew the posted information, press the “Refresh” button.
The
Link Status
in the screen will show the connection speed and duplex mode. This dialog box will display
down
when the port is disconnected.
Figure 11. Port Configuration
Note:
1.
Be sure
to reset the Gigabit port when transferring the media type ( Fiber to Copper or Copper to Fiber ).
2.
The priority of Gigabit Fiber port is higher than Copper.
To change the port setting, click on the ID parameter to enter the selected port to configure its Speed/Disable, Flow control, and QoS settings.
Figure 12.
Speed/Disable:
This setting has six modes—
100M Full
,
100M Half
,
10M Full
,
10M Half
,
Auto
,
and Disable
—for speed or port disable selections.
Flow Control:
This setting determines whether or not the Switch will be handling flow control. Set
FlowCtrl
to
Enable
to avoid data transfer overflow. It is set to
Disable
when there is either no flow control or other hardware/software management.
When the port is set to
forced mode
, the flow control will automatically be set to
Disable.
QoS:
14