D-Link DCS-3220G Product Manual - Page 31
Important, Public, Private Port, Enabled, Private IP, Protocol Type, Apply, Scheduling, Always - user manual
UPC - 790069269523
View all D-Link DCS-3220G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Using & Configuring the DCS-3220G with a NAT Router (continued) Follow these steps to configure your router's Virtual Server settings: • Click Enabled. • Enter a different name for each entry. • Enter your camera's local IP Address (e.g., 192.168.0.102 in the example in step on page 28) in the Private IP field. • Select Both under Protocol Type (TCP and UDP) • If you are using the default camera port settings, enter 80 into the Public and Private Port section, click Apply. • Scheduling should be set to Always so that the camera images can be accessed at any time. Repeat the above steps adding ports 5002 and 5003 to both the Public and Private Port sections. A check mark appearing before the entry name will indicate that the ports are enabled. Important: Some ISPs block access to port 80 and other commonly used Internet ports to conserve bandwidth. Check with your ISP so that you can open the appropriate ports accordingly. If your ISP does not pass traffic on port 80, you will need to change the port the camera uses from 80 to something else, such as 800. Not all routers are the same, so refer to your user manual for specific instructions on how to open ports. Enter the ports in the Virtual Server section of your router that correspond ot the ports you have configured on the DCS-3220G. Please make sure to check the box on this line to enable settings 31 192.168.0.102