D-Link DCS-3220G Product Manual - Page 6

Connections Antenna Connectors DC Power Connector Ethernet Cable Connector Reset Button Audio Out Connector I/O Connector Antenna Two antennas are included with the DCS-3220G. These are screwed onto the antenna connectors on the back panel to provide a connection with a wireless network. Ethernet Cable Connector The Internet Camera's back panel features an RJ-45 connector for connections to 10Base-T Ethernet cabling or 100Base-TX Fast Ethernet cabling. This network port supports the NWay protocol, allowing the Internet Camera to automatically detect or negotiate the transmission speed of the network. The Ethernet cable included with the DCS-3220G Internet Camera is a Category 5 "straight through" cable. This is the recommended cable type when the camera is physically connected to a 100 Mbps Fast Ethernet network hub or switch. Reset Button Reset will be initiated when the reset button is pressed once and held until the Power LED flashes through its cycle twice. A reset to factory defaults is initiated when the reset button is pressed continuously for 5 seconds or when the Power LED changes from green to red for 2 cycles. (For example you will see the LED turn to red twice, release the reset button when the LED turns red the second time). The Power LED will begin to flash indicating that the Internet Camera's settings are reverting back to the factory settings, then turn back to green. To reset the camera press the reset button once and the light will flash orange. 6