D-Link DFE-650TX Product Manual - Page 12

DFE-650 Series Fast Ethernet PC Card User's Guide It is most usual for the lower one of the two slots in the stack to be designated Slot 1, but there are exceptions. In the subsequent procedure for DFE-650 software installation, it may be necessary for you to know whether your DFE-650 is installed in Slot 1 or Slot 2. Under Windows 95, you can check by opening the Control Panel / PC Card display. Under DOS it is also possible to make a software check, but it is more difficult. If you are unable to determine the DFE-650's slot number in advance, then you can make a trial-and-error determination later, according to instructions given in the Software Installation section of this chapter. Step 2 Attach the Media Coupler The back-end receptacle of the DFE-650 remains accessible (approximately flush with the case of the computer) when the DFE650 is properly seated in its PC Card slot. Taking care to keep the top side of the media coupler plug up, insert the plug into the DFE650's receptacle until it is firmly seated and latched. (The top side of the plug is labeled with a triangle molded into the plastic.) Keep the triangle mark on top when you plug the media coupler into the DFE-650 NOTE: When the media coupler plug is firmly seated, it is held in place by small latching hooks at either side of the plug. To 10 Hardware Installation