D-Link DFE-650TX Product Manual - Page 39

DFE-650 Series Fast Ethernet PC Card User's Guide C:\> edit autoexec.bat then . The content of AUTOEXEC.BAT is shown in the Edit window. Notice that the line number of the cursor position is shown at the right end of the status bar (at the foot of the Edit window; the line position of the cursor is shown ahead of a colon, and the column position of the cursor within the line is shown after the colon). Take care not to introduce any inadvertent changes while you have AUTOEXEC.BAT in the Edit window. Use the down arrow key to move the cursor down until you reach the line number as found in Step 1. Check that the line marked by the cursor is the same as that displayed in Step 1. Then type in the word REMARK at the beginning of the line. Immediately save, then exit from Edit. 3. Remove the D-Link DFE-650 Series Fast Ethernet PC Card Driver diskette from its drive, and key to restart the notebook PC. 4. At the DOS prompt, insert the D-Link DFE-650 Series Fast Ethernet PC Card Driver diskette and run Installation Director, again choosing Quick Install 16-bit Driver for DOS NetWare Client and proceed with the installation run. If the installation run completes normally, then you are all through with the problem! Give yourself a big pat on the back, and return "Installing 16-bit NetWare Client for DOS" in Chapter 3. 5. If the installation run again ends with a crash (halt), then the short list item we have just tested (LSL in our example case) is not the culprit. Repeat Step 1 above, but substitute the next program named in your short list (in our example we substitute DFE650 in place of LSL): C:\> find /n/i "DFE650" autoexec.bat Troubleshooting 37