D-Link DFE-650TX Product Manual - Page 14

DFE-650 Series Fast Ethernet PC Card User's Guide Step 4 Confirm Connection (Ln/Act Indicator) When the notebook computer's power is ON, the DFE-650 is firmly seated in the slot connector, the media adapter plug is firmly engaged (and latched) in the back-end receptacle of the DFE-650, the media adapter has a good cable connection to the supporting hub, and the supporting hub is power on and functioning properly, then the media coupler's Ln/Act LED glows steady green ("linkage" state). If the Ln/Act LED remains dark without apparent cause, then the most likely fault is poor engagement of the 68-pin front-end plug. Review the following section titled "Remove the DFE-650," then remove the DFE-650 from its slot. Repeat the procedures of the above Step 1, "Insert the DFE-650," taking care to ensure that the DFE-650 is right side up and front-end first, and that it seats firmly in a suitable PC Card slot of your notebook. Repeat procedures of Steps 2 and 3 as necessary get the Ln/Act LED confirmation. NOTE: You might need to wait a few seconds following notebook powerup, or following insertion of a PC Card, for the software processing to be completed. The Ln/Act indicator will remain dark until the software processing is completed. Remove the PC Card Follow these two steps to remove the DFE-650 its slot: Step 1 Disconnect the Media Coupler Plug from the DFE-650 Unplug the media coupler from the DFE-650 before ejecting the DFE-650 from the PC Card slot. The media coupler plug is held in place by small latching hooks at either side of the plug. To remove the media coupler plug from the DFE-650, it is necessary to unlatch the hooks by depressing the two small latch wings of the plug. Use 12 Hardware Installation