D-Link DFE-650TX Product Manual - Page 32

Troubleshooting

Get D-Link DFE-650TX PDF manuals and user guides View all D-Link DFE-650TX manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

A Troubleshooting Troubleshooting the Hardware Installation If you experience any problems with the hardware installation, first ascertain that all network cable connections are firm, that the proper grade of cable is used for the network connection, and that the cable makeup is correct (straight -- without un-needed crossovers in the connector wiring). Check that the supporting hub is power-on and operating normally, and that the hub is properly qualified (under 10Base-T and/or 100Base-TX standards). Troubleshooting the Software Installation You Get the %')(0983 3& &DUG 1RW 'HWHFWHG% Error You are running Installation Director, and in the Main Menu you have selected Quick Install 16-bit Driver for Dos Netware Client The Quick Install run is then interrupted by an error message which says that the DFE-650 PC Card is not detected by the system. You have followed the instruction given by the error message, to repeat Step 1 of the Hardware Installation procedure given at the beginning of Chapter 2 of the User's Guide. And you have then rerun Installation Director. And the same error message has come up.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
A
Troubleshooting
Troubleshooting the
Hardware
Installation
If you experience any problems with the hardware installation, first
ascertain that all network cable connections are firm, that the
proper grade of cable is used for the network connection, and that
the cable makeup is correct (straight
––
without un-needed
crossovers in the connector wiring).
Check that the supporting hub
is power-on and operating normally, and that the hub is properly
qualified (under 10Base-T and/or 100Base-TX standards).
Troubleshooting the Software Installation
You Get the
%
’)(
0983
3& &DUG 1RW ’HWHFWHG
%
Error
You are running Installation Director, and in the Main Menu you
have selected
Quick Install 16-bit Driver for Dos Netware Client
The Quick Install run is then interrupted by an error message which
says that the DFE-650 PC Card is not detected by the system.
You have followed the instruction given by the error message, to
repeat Step 1 of the Hardware Installation procedure given at the
beginning of Chapter 2 of the User's Guide.
And you have then re-
run Installation Director.
And the same error message has come up.