D-Link DGS-1510-28P User Manual - Page 44

DGS-1510 Series Gigabit Ethernet SmartPro Switch Hardware Installation Guide • IEEE 802.3ae compliance • IEEE 802.3z compliance SFP Transceivers Supported: All SFP and WDM transceivers listed in the SFP Ports section (above) will also work in the SFP+ ports. SFP+ Transceivers Supported: • DEM-431XT-DD (10GBASE-SR SFP+ Transceiver, 80m: OM1 & OM2 MMF 300m: OM3 MMF) • DEM-431XT (10GBASE-SR SFP+ Transceiver (w/o DDM), 80m: OM1 & OM2 MMF 300m: OM3 MMF) • DEM-432XT-DD (10GBASE-LR SFP+ Transceiver, 10km) • DEM-432XT (10GBASE-LR SFP+ Transceiver (w/o DDM), 10km) • DEM-433XT-DD (10GBASE-ER SFP+ Transceiver, 40km) • DEM-433XT (10GBASE-ER SFP+ Transceiver (w/o DDM), 40km) • DEM-434XT (10GBASE-ZR SFP+ Transceiver (w/o DDM), 80km) • DEM-436XT-BXU (10GBASE-LR BiDi SFP+ Transceiver (w/o DDM), 20km, TX: 1270nm, RX: 1330nm) • DEM-436XT-BXD (10GBASE-LR BiDi SFP+ Transceiver (w/o DDM), 20km, TX: 1330nm, RX: 1270nm) PoE Ports (DGS-1510-28P Only) SFP+ Direct Attached Cables (DAC) Supported: • DEM-CB100S-10-GbE (SFP+, 1m, Direct Attach Cable), for stacking. • DEM-CB300S-10-GbE (SFP+, 3m Direct Attach Cable), for stacking. • DEM-CB700S-10-GbE (SFP+, 7m Direct Attach Cable), for stacking. 1. Supports IEEE 802.3af PoE and IEEE 802.3at PoE+ compliance. 2. Supplies power (ports 1 to 24) to PD devices up to 15.4 Watt per port (802.3af) or 30 Watt per port (802.3at) and more sufficiently is able to provide power to PD devices. 3. The auto-discovery feature automatically recognizes the connection of the PD device and immediately provides power. 4. Automatically disable ports if the port current is over 600mA while. Other ports will remain active. 5. Active circuit protection automatically disables the port if there is a short while other ports remain active. 6. For 802.3af/at capable devices it will provide the power for the following classifications below: 44