D-Link DGS-3630-52TC Web UI Reference Guide 2 - Page 327
PIM for IPv6 SPT Threshold Settings
View all D-Link DGS-3630-52TC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 327 highlights
DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide Parameter Description register checksum methodology is PIM RFC-compliant, excluding the data portion in the Register message. Click the Apply button to accept the changes made. The fields that can be configured in Register Probe Time are described below: Parameter Register Probe Description Enter the register probe time value here. The range is from 1 to 127 seconds. The register-probe time is the time before the Register-Stop Timer (RST) expires when a DR may send a Null-Register to the RP to cause it to resend a RegisterStop message. Select the Default option to use the default value, which is 5 seconds. Click the Apply button to accept the changes made. The fields that can be configured in Register Suppression Time are described below: Parameter Register Suppression Description Enter the register suppression timeout value here. The range is from 3 to 65535 seconds. When a DR receives the register-stop message, it will start the suppression timer. During the suppression time a DR will stop sending Registerencapsulated data to the RP. This timer should be configured on the designated router. The value of the Register Probe Time must be less than half the value of the Register Suppression Time to prevent a possible negative value in the setting of the Register-Stop Timer. The minimal value for Register Suppression Time is 3. Select the Default option to use the default value, which is 60 seconds. Click the Apply button to accept the changes made. PIM for IPv6 SPT Threshold Settings This window is used to display and configure the Shortest Path Tree (SPT) threshold settings. To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for IPv6 SPT Threshold Settings, as shown below: Figure 6-142 SPT Threshold Settings Window The fields that can be configured are described below: Parameter SPT Threshold Description Select the SPT threshold value here. Options to choose from are 0 and Infinity. Select the Default option to use the default setting, which is Infinity. • 0 - Specifies to establish the source tree right at the arrival of the first packet. • Infinity - Specifies to always rely on the shared tree. Click the Apply button to accept the changes made. 315