D-Link DGS-3630-52TC Quick installation Guide - Page 250

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide The fields that can be configured are described below: Parameter IPv6 MTU IPv6 State Description Enter the IPv6 MTU value here. The range is from 1280 to 65534 bytes. By default, this value is 1500 bytes. This parameter is used to configure the MTU to be advertised in RA messages. Select to enable or disable the IPv6 interface global state here. Click the Back button to discard the changes made and return to the previous page. Click the Apply button to accept the changes made. The fields that can be configured for IPv6 Address Autoconfig are described below: Parameter State Description Select to enable or disable the automatic configuration of the IPv6 address using stateless auto-configuration here. Select the Default option to specify that if the default router is selected on this interface, a default route will be installed using that default router. This option can only be specified on one interface. Click the Apply button to accept the changes made. The fields that can be configured for Static IPv6 Address Settings are described below: Parameter IPv6 Address Description Enter the IPv6 address for this IPv6 interface here. Select the EUI-64 option to configure an IPv6 address on the interface using the EUI-64 interface ID. Select the Link Local option to configure a link-local address for the IPv6 interface. Click the Apply button to accept the changes made. The fields that can be configured for NS Interval Settings are described below: Parameter NS Interval Description Enter the Neighbor Solicitation (NS) interval value here. The range is from 0 to 3600000 milliseconds, in multiples of 1000. If the specified time is 0, the router will use 1 second on the interface and advertise 0 (unspecified) in the Router Advertisement (RA) message. Click the Apply button to accept the changes made. The fields that can be configured for ND Settings are described below: Parameter Hop Limit Reachable Time Managed Config Flag Other Config Flag Description Enter the hop limit value here. The range is from 0 to 255. The IPv6 packet originated by the system will also use this value as the initial hop limit. Enter the Reachable Time here. The range is from 0 to 3600000 milliseconds. If the specified time is 0, the router will use 1200 seconds on the interface and advertise 0 (unspecified) in the RA message. The Reachable Time is used by the IPv6 node in determining the reachability of the neighbor nodes. Turn the Managed Config Flag option On or Off here. When the neighbor host receives the RA which has flag turned on, the host should use a stateful configuration protocol to obtain IPv6 addresses. Turn the Other Config Flag option On or Off here. By setting the other configuration flag on, the router instructs the connected hosts to use a stateful configuration protocol to obtain auto-configuration information other than the IPv6 238