Dacor ER30D Installation Instructions
Dacor ER30D Manual
 |
View all Dacor ER30D manuals
Add to My Manuals
Save this manual to your list of manuals |
Dacor ER30D manual content summary:
- Dacor ER30D | Installation Instructions - Page 1
Installation Instructions Epicure® Range For use with models ER30D, ER30D-C, ER30DSR Part No. 102187 Rev. J THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI Z21.1 STANDARD FOR HOUSEHOLD GAS COOKING APPLIANCES. - Dacor ER30D | Installation Instructions - Page 2
All specifications subject to change without notice. Dacor® assumes no liability for changes to specifications. © 2007 Dacor, all rights reserved. - Dacor ER30D | Installation Instructions - Page 3
Instructions and warnings in this manual are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or operating this or any other appliance. Always contact the Dacor Customer Service Team about problems of the range or list - Dacor ER30D | Installation Instructions - Page 4
Your Range section of the use and care manual for the location of the various air holes (slots). • Only use the range for part of the range unless specifically instructed to do so in these instructions. • To prevent the unit from tipping forward and to provide a stable installation, this range - Dacor ER30D | Installation Instructions - Page 5
Web site: www.Dacor.com Dacor Distinctive Service (for repairs under warranty only) Phone: (877) 337-3226 (U.S.A. and Canada) Monday - Friday 6:00 a.m. to 4:00 p.m. Pacific Time Serial number and rating labels located inside unit, behind grill Model Identification ER30DSR-C-SCH/NG/H SIZE (inches - Dacor ER30D | Installation Instructions - Page 6
to the ratings on the range rating label. ER30D/ER30DSR ELECTRICAL SPECIFICATIONS Circuit Required Total listed on the rating label. • Suggested wiring color code: black, white, red and green. • The wiring needs to be long enough to allow the range to be pulled out from the wall for service - Dacor ER30D | Installation Instructions - Page 7
hole size must be increased to 1 1/8" by removing the conduit bracket inside the range electrical access box. A C 7/8" (22 mm) Dia. electrical connection hole NOTE: Models ER30D and ER30D-C are NOT designed for use with self-rimming installations or raised vents. Use model ER30DSR for self-rimming - Dacor ER30D | Installation Instructions - Page 8
stated NOTE: Self-rimming models are not compatible with Dacor integral backguards. NOTE: Self-rimming models are designed 7/8" (962 mm) 1 9/16" (40 mm) Width at front panel: 29 7/8" (758 mm) Self-Rimming Model ER30DSR with Standard Trim 46 1/8" (1172 mm) 28 11/16" (729 mm) 27 3/16" (691 mm) 26 - Dacor ER30D | Installation Instructions - Page 9
to reduce accumulated smoke in the room, Dacor strongly recommends installing a range hood. A range hood should project horizontally a minimum of range can be pulled out for service while the appliance remains connected. Cutout tolerances: +1/16" (+1.6 mm), -0 F WARNING Do not operate the range - Dacor ER30D | Installation Instructions - Page 10
the Range Unpack the range and verify that all required parts have been provided. If any item is missing or damaged, please contact your dealer immediately. Do not install a damaged or incomplete appliance. The customer must report cosmetic issues within 30 days of installation. 8 Parts List - Dacor ER30D | Installation Instructions - Page 11
Installation Instructions Changing the Backguard (models ER30D and ER30D-C only) Models ER30D and ER30D-C come standard with a 3" backguard installed. The onto the range. 4. Fasten the new trim pieces in place using the existing screws. Installing the ARSP3 3-Inch Side Panel Kit (model ER30DSR only) - Dacor ER30D | Installation Instructions - Page 12
Installation Instructions ARSP3 Side Panel Kit Installation (cont.) 2. Close the door. Remove and retain the two screws from the back of the kick panel as shown below. Pull the kick panel free from the front of the unit. 5. Insert the tabs on the trim piece into the slots on the range. 6. Use the - Dacor ER30D | Installation Instructions - Page 13
existing screws A B Installing a Raised Vent (Optional) Install the ERV30 or PRV30 raised vent before final installation of the range. See the raised vent installation instructions, part no. 65335. IMPORTANT: The ERV30 or PRV30 raised vent attaches to the narrow back portion of the raised vent - Dacor ER30D | Installation Instructions - Page 14
NOTE: Freestanding model ER30D-C is wired for use in Canada and comes from the factory pre-wired. If installing a pre-wired range, skip to Gas range to be pulled out for service without disconnecting it from power. • Do not disconnect any of the wires inside the range electrical box unless instructed - Dacor ER30D | Installation Instructions - Page 15
wire unless local building codes permit. Connecting Conduit to the Range NOTE: See pages 16 and 17 for instructions to connect an appliance cord to the range. 1. Remove the range electrical access cover from the back of the range. L1 terminal Neutral terminal Jumper link L2 terminal Black wire - Dacor ER30D | Installation Instructions - Page 16
Installation Instructions Electrical Connection (Continued) Connecting the Conduit to the House Electrical Junction Box WARNING • Do not ground the appliance to a gas supply pipe or hot water pipe. • Do not turn on power to the appliance until the range is permanently grounded. • A grounded cold - Dacor ER30D | Installation Instructions - Page 17
Installation Instructions Connection to power supply Junction box Separate No. 10 (minimum) copper grounding wire Fasten clamp tightly on pipe Wire nut 4 places Connection to appliance (Page - Dacor ER30D | Installation Instructions - Page 18
Instructions Electrical Connection (Continued) Appliance Cord Connections - Where Local Code Permits WARNING Do not connect the green appliance wire to the neutral (white) supply wire unless local building codes permit. 1. Remove the range electrical access cover from the back of the range parts - Dacor ER30D | Installation Instructions - Page 19
. • Check for gas leaks as instructed below before using the appliance. Do not range rating label (see page 3 for location). Ranges intended for use with LP gas will have "LP" as a part of the model number. Consult your dealer if the range to allow the range to be pulled out for service. 3. Slide - Dacor ER30D | Installation Instructions - Page 20
Installation Instructions Final Installation 1. Peel the protective plastic coating off of the range, including the range door. 2. Carefully slide the range into position in the cutout. The rear anti-tip leg should engage the anti-tip bracket. 3. On self-rimming installations, reach under the range - Dacor ER30D | Installation Instructions - Page 21
Installation Instructions Cooktop Assembly WARNING Never attempt to operate the range's cooktop with any of the burner rings, burner caps or grates removed. • Remove the burner rings, burner caps and grates from their shipping packages. • Install - Dacor ER30D | Installation Instructions - Page 22
checklist should be completed by the installer to ensure that no part of the installation has been overlooked. • Proper installation is the responsibility of the homeowner. The importance of proper installation of your Dacor range cannot be overemphasized. □□ Has the plastic coating been peeled off - Dacor ER30D | Installation Instructions - Page 23
- Dacor ER30D | Installation Instructions - Page 24
Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.Dacor.com
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
Installation Instructions
Epicure
®
Range
Part No. 102187
Rev. J
THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION
OF ANSI Z21.1 STANDARD FOR HOUSEHOLD GAS COOKING APPLIANCES.
For use with models ER30D, ER30D-C, ER30DSR