Dacor ER30D Installation Instructions - Page 15

Installation Instructions Connecting the Wiring to the Range Refer to the range rating label (see page 3) for power requirements. There are four possible ways to wire the range: • 4 wire conduit • 3 wire conduit (where local codes permit) • 4 wire appliance cord (where local codes permit) • 3 wire appliance cord (where local codes permit) The sections below and on the following pages give directions for connecting each type of wiring harness. WARNING Do not connect the green appliance wire to the neutral (white) supply wire unless local building codes permit. Connecting Conduit to the Range NOTE: See pages 16 and 17 for instructions to connect an appliance cord to the range. 1. Remove the range electrical access cover from the back of the range. L1 terminal Neutral terminal Jumper link L2 terminal Black wire White wire Red wire Conduit strain relief nut 3 Wire Conduit Connection Where Local Code Permits 2. If using a 4 wire connection, loosen the grounding screw and remove the neutral to ground jumper link. 3. Remove the nut from the conduit strain relief (not included). 4. Slide the wires and the end of the strain relief into the hole on the bottom of the range electrical box. 5. Before connecting the wires, slide the strain relief nut over the wires and thread it onto the conduit strain relief inside the box. Tighten into place. 6. Connect the white wire to the neutral terminal in the box. 7. Connect the black wire to the L1 power supply terminal. 8. Connect the red wire to the L2 power supply terminal. 9. If using a 4 wire connection, connect the green wire to the grounding screw inside the box. 10. Replace the range electrical access cover. Bare wire connections L1 terminal Neutral terminal L2 terminal Link removed Grounding screw Red wire Green wire White wire Black wire Conduit strain relief nut Loop and spade terminal connections 4 Wire Conduit Connection 13