Dacor ER30D Installation Instructions - Page 11
Installation Instructions
View all Dacor ER30D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Installation Instructions Changing the Backguard (models ER30D and ER30D-C only) Models ER30D and ER30D-C come standard with a 3" backguard installed. The 6" and 9" backguards are optional. To change the backguard: 1. Remove and retain the three (3) chrome screws on the front of the existing backguard. 2. Remove and retain the two (2) upper screws on the back of the side panels. 3. Slide the existing backguard off the unit. Installing the ATK30SR Raised Vent Trim Kit (model ER30DSR only) To install the optional raised vent with self-rimming model ER30DSR, you must install the optional raised vent trim kit. To change the trim on model ER30DSR: 1. Remove and retain the seven (7) chrome screws that hold the existing trim pieces in place. 2. Slide the existing trim pieces off the range. 4. Place the new backguard over the back of the range. 5. Fasten the backguard using the five (5) existing screws. New backguard, height varies 3. Slide the new trim pieces onto the range. 4. Fasten the new trim pieces in place using the existing screws. Installing the ARSP3 3-Inch Side Panel Kit (model ER30DSR only) For self-rimming installations with non-standard countertop depths, installation of the optional side panel kit may be necessary to cover the sides of the range that protrude from the cabinet. To install the side panel kit: 1. Open the oven door. Remove and retain the two (2) screws on the top of the kick panel. The screws are accessed through the space between the door and the oven opening. Space between door and oven opening Remove and retain screws Continued... 9