Dacor ER30D Installation Instructions - Page 14

Installation Instructions Removing the Oven Door WARNING • Do not attempt to disengage the hinge catches with the door removed from the oven. The hinge springs could release causing personal injury. • Do not lift or carry the oven door by the handle. To make the range easier to move, remove the door to reduce weight. 1. Open the door to its fully opened position. 2. Rotate the catch over the retaining arm on each hinge. Catch Electrical Connection WARNING • Wire the range only in compliance with local ordinances. • Do not turn on power to the range until instructed to do so in the Verifying Proper Operation section of these instructions. • Improper connection of the electrical wiring can cause an electric shock hazard and damage the appliance. Dacor is not responsible for damages resulting from improper installation. • The ground terminal (or lead) on the appliance must be connected to a grounded, metallic, permanent wiring system or grounding conductor. • Do not use an extension cord with this appliance. Such use may result in fire, electric shock or other personal injury. • Do not install a fuse in the neutral or ground circuit. A fuse in the neutral or ground circuit may result in an electric shock hazard. NOTE: Freestanding model ER30D-C is wired for use in Canada and comes from the factory pre-wired. If installing a pre-wired range, skip to Gas Supply Connection on page 17. Retaining arm 3. Lift the oven door to about a 15° angle from the vertical position. 4. Hold the door with both hands just below the handle and pull it away from the oven while continuing to lift. Put slack in electrical wiring and gas line IMPORTANT: • Make sure that the conduit or appliance cord is long enough to allow the range to be pulled out for service without disconnecting it from power. • Do not disconnect any of the wires inside the range electrical box unless instructed to do so. Door Gripping Points 12 Electrical access cover Back of range