Dacor ER30D Installation Instructions - Page 12

Installation Instructions ARSP3 Side Panel Kit Installation (cont.) 2. Close the door. Remove and retain the two screws from the back of the kick panel as shown below. Pull the kick panel free from the front of the unit. 5. Insert the tabs on the trim piece into the slots on the range. 6. Use the hex head screw (83023) removed from the side, a Torx head screw removed from the kick panel and the hex screws from the kit to attach the side panel to the range. Three (3) hex head screws attach the side. One (1) Torx head screw (83709) inserts through the end cap hole to attach the top of the side panel. One (1) Torx head screw (83709) inserts through a hole in the front panel to attach the bottom of the side panel. Hex screw Kick panel Remove and retain screw, both sides 3. Remove the left end cap retaining screw from under the rim of the control panel and remove the end cap. Side panel Hex screw Hex screw End cap 7. Reinstall the end cap. Torx screw Torx screw Front panel 4. Hold the left side panel in position on the side of the range. Locate the center mounting hole. Remove and retain the screw attached to the chassis beneath it. Side panel Center mounting hole Left side only: Remove and reuse this screw. 10 8. Repeat steps 3 to 7 for the right side panel. NOTE: There is an additional hex screw (83023) in the kit for the right side panel because the center mounting screw is not reused as with the left side (do not perform step 4).