Dacor ER30D Installation Instructions - Page 18

Installation Instructions Electrical Connection (Continued) Appliance Cord Connections - Where Local Code Permits WARNING Do not connect the green appliance wire to the neutral (white) supply wire unless local building codes permit. 1. Remove the range electrical access cover from the back of the range. 2. If using a 4 wire connection, loosen the grounding screw and remove the neutral to ground jumper link. 3. Remove the conduit bracket from the bottom of the range electrical box. 5. Slide the end of the appliance cord into the strain relief from the bottom of the box. 6. Connect the white (neutral) wire to the neutral terminal in the box. 7. Connect the L1 wire to the L1 power supply terminal in the box. 8. Connect the L2 wire to the L2 power supply terminal in the box. 9. If using a 4 wire connection, connect the ground wire to the grounding screw inside the box using a loop or spade terminal. 10. Tighten the strain relief so that the appliance cord is held snuggly in place. 11. Replace the range electrical access cover. L1 terminal Neutral terminal L2 terminal Jumper link Remove link on 4 wire installations Remove conduit bracket before strain relief installation 4. Disassemble and remove the strain relief from the appliance cord (not included). Insert the tabs on the two parts of the strain relief into the hole on the bottom of the box and reassemble it so that the tabs are below the box and the strain relief itself is inside the box. Strain relief L1 wire White wire L2 wire Strain relief 3 Wire Appliance Cord Connection - Where Local Code Permits L1 Neutral Bottom of range electrical box 16 Reassemble with tabs below and clamp above L2 10-50P Plug