DeLonghi ESAM6700 Owner Manual - Page 16

the cup used. Put the cup for long coffee under the spouts (fig. 18); 3. Choose the strength by hitting the and size by hitting the . 4. Press the LONG icon (fig. 10). Preparation begins. A progress bar appears on the display and gradually advances as the procedure progresses. Information: • While the machine is making coffee, delivery can be interrupted at any moment by pressing the LONG icon. • Only one cup of long coffee can be made at a time. • When delivering more than 4.2 oz, the appliance automatically grinds more coffee halfway through delivery. Making espresso or long coffee using preground coffee Important! • Never add pre-ground coffee when the machine is off or it could spread through the inside of the machine and dirty it. • Never use more than one level measuring scoop or it could dirty the inside of the machine or block the funnel. Information: If you use pre-ground coffee, you can only make one cup of coffee at a time. 1. Press the icon repeatedly (fig. 7) until "Pre-ground" flashes on the display. 2. Put one level measuring scoop of pre-ground coffee into the funnel (fig. 19). 3. Place a cup under the coffee spouts. 4. To make espresso coffee, press the one cup icon (fig. 9). To make a long coffee, press the LONG icon (fig. 10). Information: LONG COFFEE: when delivering more than 4.2 oz, the appliance requests a new level measure of pre-ground coffee halfway through delivery. When you have added the preground coffee, confirm by pressing the OK icon. MAKING DRINKS WITH MILK Filling and attaching the milk container 1. Turn the lid of the milk container clockwise until it becomes noticeably difficult to turn, then remove the lid (fig. 20). 2. Fill the milk container with a sufficient quantity of milk, not exceeding the MAX level marked on the handle (fig. 21). Information! We recommend using skim or 2% milk at refrigerator temperature (about 41°F). To avoid milk with poor froth or large bubbles, always clean the milk lid and hot water nozzle as described in the section "Cleaning the milk container" on page 19. 3. Make sure the milk intake tube is correctly inserted in the bottom of the milk container lid (fig. 22). 4. Replace the milk container lid and turn counterclockwise as far as it will go until you hear it click. 5. Remove the hot water spout from the nozzle (fig. 23). 6. Attach the container to the nozzle and push as far as it will go (fig. 24). The machine emits a beep when milk container is attached correctly (if the beep function is enabled). 7. Place a sufficiently large cup under the coffee spouts and frothed milk spout. To use particularly tall cups/glasses, raise the lid (A17) of the special compartment in the cup tray (fig. 25). Making latte 1. After attaching the milk container, place frothed milk regulator (B1) on lid to position 1 for LATTE (fig. 26). 2. Press the LATTE icon (fig. 27). The message "Caffelatte... Jug selector in position: 1" appears. After a few seconds, frothed milk is delivered from the milk spout into the cup below. The milk will stop automatically and delivery of coffee will begin. Information: If during delivery you want to stop preparing milk, press the LATTE icon or interrupt preparation of the coffee by pressing the icon. 15