DeLonghi ESAM6700 Owner Manual - Page 22

DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY FILL TANK! • The water tank is empty or positioned incorrectly. • Fill the tank with water and/or insert it correctly, pushing it as far as it will go. GROUND TOO FINE • The grinding is too fine and the coffee is • Make the coffee again and turn the ADJUST MILL! Insert water spout and delivered too slowly. grinding adjustment knob one click clockwise towards "7" while the coffee mill is in operation. The effect is only press OK visible after delivering two coffees. • The machine cannot make coffee as there is air in the hydraulic circuit • Press the OK icon to deliver water from the spout until it flows out normally. INSERT WATER SPOUT! • The water spout is not inserted or is inserted incorrectly. • Insert water spout as far as it will go. EMPTY GROUNDS CONTAINER • The grounds container is too full or • Empty the grounds container and clean, more than 3 days have passed since you then replace. last made coffee (this guarantees correct Important: when removing the drip tray, hygiene of the machine). the grounds container MUST be emptied, even if it is not completely full. If this is not done, when you make the next coffees, the grounds container may fill up more than expected and clog the machine. INSERT GROUNDS CONTAINER • After cleaning, the grounds container has not been replaced. • Open the service door and insert the grounds container. If grounds container is inside the machine and message is still displayed, there may be a damaged mircoswitch and customer service should be called. INSERT MILK CONTAINER! • The milk container is not inserted. . • Insert milk container as far as it will go. DESCALE! • LESS COFFEE! • ADD PRE-GROUND • COFFEE! • FILL BEANS • CONTAINER! INSERT BREW GROUP • ASSEMBLY! CLOSE DOOR! • The machine must be descaled. • Too much ground coffee has been used. • The "pre-ground coffee" function has • been selected without placing any pre- ground coffee in the funnel. The funnel (A8) is blocked. • The coffee beans have run out. • The brew group has not been replaced • after cleaning. The service door is open • The descaling procedure described in the "Descaling" section needs to be performed as soon as possible. Select a milder taste or reduce the quantity of pre-ground coffee, then make the coffee again. Place pre-ground coffee in the funnel. Empty the funnel with the help of a dull knife, as described in the section "Cleaning the pre-ground coffee feed funnel". Fill bean container Insert the brew group as described in the section "Cleaning the brew group". Close the service door. 21