Dell 1135N Service Manual - Page 97
Error Message
View all Dell 1135N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Alignment and Troubleshooting 4.1.10 Error Message Messages appear on the control panel display to indicate the machine's status or errors. Refer to the tables below to understand the messages' and their meaning, and correct the problem, as is necessary. Checking display messages • If a message is not in the table, reboot the power and try the printing job again. • Some messages may not appear in the display depending on the options or models. • [error number] indicates the error number. • [tray type] indicates the tray number. • [media type] indicates the media type. • [media size] indicates the media size. • [color] indicates the color of toner or imaging unit. Message [COMM. Error] [Incompatible] [Line Error] [No Answer] [Stop Pressed] ADF COVER OPEN ERROR BOOTP problem Auto IP Run BOOTP problem Reconfigure DHCP DHCP problem Reconfigure BOOTP Meaning Suggested solutions The machine has a communication problem. Ask the sender to try again. The machine has received a fax which The received fax data will be deleted. is registered as a junk fax. Reconfirm junk fax setup. Your machine cannot connect with the receiving fax machine or has lost contact because of a problem with the phone line. Try again. If the problem persists, wait an hour or so for the line to clear and try again. Or, turn the ECM mode on. The receiving fax machine has not Try again. Make sure that the receiving answered after several redial ttempts. machine is operational and has paper. Stop/Clear has been pressed during Try again. an operation. The ADF cover is opened. Close the ADF cover. The IP address assignment is failed. This happens, when Auto IP for BOOTP is set in SyncThru Web Service. Change the IP address assignment method to DHCP or Static. If you do not change this option, the BOOTP server continually asks to assign the IP Address. The IP address assignment is failed. This happens, when Auto IP for BOOTP is not set in SyncThru Web Service. Change the IP address assignment method to DHCP or Static. If you do not change this option, the BOOTP server continually asks to assign the IP Address. The IP address assignment is failed. Change the IP address assignment This happens, when Auto IP for DHCP method to BOOTP or Static. If you is set in SyncThru Web Service. do not change this option, the DHCP server continually asks to assign the IP Address. Service Manual 4-24