Dell 2330d Service Manual - Page 43

Error Description Action 931.01 No first hsync 932.00 Lost hsyncs 932.01 Lost hsyncs 933.01 Printhead boost signal failure 934.00 Mirror motor lost lock. 934.01 Mirror motor lost lock. 935.00 No initial mirror motor lock 935.01 Timed out waiting for mirror motor lock 935.10 Printhead sweep error, swept through Hz range without finding the resonant frequency 935.12 Printhead sweep error, coarse sweep state 935.15 Printhead open-loop error, check prelim amp state 935.16 Printhead open-loop error, enable amp Kp state 935.17 Printhead closed-loop error, amp Kp failed to converge 935.18 Printhead closed-loop error, enable amp Ki state 935.19 Printhead closed-loop error, amp Ki failed to converge 935.20 Printhead closed-loop error, enable offset controller state 935.21 Printhead closed-loop error, load scan regs state 935.22 Printhead closed-loop error, fwd and rev capture times differ by too much 935.23 Printhead closed-loop error, check sweep accuracy state 935.25 Printhead closed-loop error, off-resonant PI effort state 935.26 Timed out on POR sweep 935.27 Exceeded maximum open loop drive level when configuring for sweep re-try. 935.28 Exceeded maximum open loop drive level when setting operating Hz. Transport motor service errors 936.01 No lock detected at normal motor start 936.02 No lock detected at motor start for motor ID 936.03 No halls detected at motor start 936.04 Failed to stop within timeout 936.05 Stall detected during speed control Replace the printhead. See "Printhead service check" on page 2-37. Replace the main motor gear drive. See "Main motor service check" on page 2-26 Diagnostics information 2-17