Dell 2330d Service Manual - Page 75
Output bin tests, Base sensor test (B. sensor test), Feed Tests, Sensor Test - specifications
UPC - 884116003618
View all Dell 2330d manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Output bin tests The Output bin tests setting is used to test the printer's output bins and its sensors. Feed Tests This test verifies that the media from the printer's default input source feeds to the specific output bin. Press to select Single, or press and to select Continuous. The Single test feeds one sheet of media to the default output bin. No buttons are active during this test. The Continuous test feeds media to the default output bin until is pressed. The indicator light blinks green, and the operator panel displays [Select Output Bin] Feeding... while either of these tests perform. Sensor Test This test verifies that the selected output bin's sensors are working correctly. The following sensors are available in each output bin: Output bin Full sensor Near full sensor Passthru 1 sensor Passthru 2 sensor Standard bin ✔ x x x -bin Mailbox x x ✔ ✔ *This sensor will register the following levels: "empty," "normal," "near full," and "full. Level sensor* x ✔ Press to select this test from the Output bin tests menu, and then press again to select the desired output bin. Closed will display on the operator panel if the sensor is closed. Open will display on the operator panel if the sensor is open. If the wrong message is displayed, then the sensor is malfunctioning. To exit the Sensor Test, press or . Base sensor test (B. sensor test) The Base Sensor Test verifies the correct functioning of the following sensors: • Input • Sensor Tests • Front Door • Standard bin • S1 • S2 • Fuser Exit • C-TMC • M-TMC • Y-TMC • K-TMC This test toggles each of these sensors. If a sensor does not toggle, then the sensor is malfunctioning. To exit the Base Sensor Test, press or . Diagnostic aids 3-11