Dell 5310n Service Manual - Page 115
displays, displays-May be able to clear message and feed paper into bin, selected
UPC - 807027103086
View all Dell 5310n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
271.xx Paper Jam-Check Bin 1 displays FRU 1 Bottom pass thru sensor flag assembly Control board Action Check the flag for correct operation, binding, broken parts, or interference from the sensor cable. If incorrect, repair as necessary. If correct, make sure the bottom pass thru sensor is correctly connected to J5 on the control board. Disconnect the pass thru sensor cable and check the voltage at J5-3. The voltage measures approximately +5 V dc. If incorrect, check the voltage at J5-2. The voltage measures approximately 0 V dc. If incorrect, replace the sensor assembly. If this does not fix the problem, replace the control board. 274.xx Paper Jam-Check Bin 4 displays Service tip: When a 274.xx Paper Jam Check Bin 4 message displays, a problem exists with the top pass thru sensor assembly or the control board. FRU 1 Top pass thru sensor flag assembly Control board Action Check the flag for correct operation, binding, broken parts or interference from the sensor cable. If incorrect, repair as necessary. If correct check to make sure the top pass thru sensor is correctly connected to J11 on the control board. Disconnect the pass thru sensor cable and check the voltage at J11-3 The voltage measures approximately +5 V dc. If incorrect, check the voltage at J11-2. The voltage measures approximately 0 V dc. If incorrect, replace the sensor assembly. If this does not fix the problem, replace the lower control board. Ready Bin x Full displays-May be able to clear message and feed paper into bin selected FRU 1 Bin x sensor Bin x sensor cable Bin x sensor flag Control board Action Check the sensor and sensor cable for the bin that is displaying the message to make sure the sensor is seated correctly in the side of the tray and the cable is connected to the sensor and the control board. Check the flag for binding and proper operation. If correct, replace the bin x sensor. If this does not fix the problem, replace the control board. Note: This sensor is in a normally open position with the flag out of the sensor slot. Bin x is Full-message that bin x is full does not display FRU 1 Bin x sensor Bin x sensor cable Bin x sensor flag Bin x sensor flag Control board Action Check the sensor flag for binds, broken or missing parts. If correct, check the bin sensor for correct installation in the side of the tray. If the bin sensor is installed correctly, check the sensor cable for correct installation to the sensor and control board. If correct, replace the bin x sensor. If this does not fix the problem, replace the control board. Diagnostic information 2-73