Dell 5310n Service Manual - Page 61
temperature after, increasing inter
UPC - 807027103086
View all Dell 5310n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Service error codes (9xx.xx) (continued) Error code Sub codes Description Possible causes 922 .44 922 .45 922 .46 922 .47 922 .52 922 .53 922 .54 922 .55 Hot roll timed out in trying to reach the final lamp detection temperature. Fuser page count between 400,000 and 499,999. • Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Fuser not receiving sufficient AC power. • Poor supply line voltage. After hot roll lamp detection, did not roll over to steady state control in time. Fuser page count between 400,000 and 499,999. The control code has been lost. Hot roll did not reach operating temperature in time (new enhanced control). Fuser page count between 400,000 and 499,999. • Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Fuser not receiving sufficient AC power. • Poor supply line voltage. Fuser has taken too long to reach desired temperature after increasing interpage gap. Fuser page count between 400,000 and 499,999. • Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Excessive load on the fuser. • Fuser not receiving sufficient AC power. • Poor supply line voltage. Hot roll took too long to reach the beginning lamp detection temperature. Fuser page count stopped at 500,000 to preserve data. • Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Fuser not receiving sufficient AC power. • Poor supply line voltage. Hot roll reached final lamp detection temperature but took longer than largest time in lookup table. Fuser page count stopped at 500,000 to preserve data. • Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Fuser not receiving sufficient AC power. • Poor supply line voltage. Hot roll timed out in trying to reach the final lamp detection temperature. Fuser page count stopped at 500,000 to preserve data. • Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Fuser not receiving sufficient AC power. • Poor supply line voltage. After hot roll lamp detection, did not roll over to steady state control in time. Fuser page count stopped at 500,000 to preserve data. The control code has been lost. Action Go to "922.xx-Cold fuser check" on page 2-89. Go to "922.xx-Cold fuser check" on page 2-89. Go to "922.xx-Cold fuser check" on page 2-89. Go to "922.xx-Cold fuser check" on page 2-89. Go to "922.xx-Cold fuser check" on page 2-89. Go to "922.xx-Cold fuser check" on page 2-89. Go to "922.xx-Cold fuser check" on page 2-89. Go to "922.xx-Cold fuser check" on page 2-89. Diagnostic information 2-19