Dell DR4000 Owner's Manual - Page 147
Close the system. See Closing the System on password function. See Table 6-1.
View all Dell DR4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
The existing passwords are not disabled (erased) until the system boots with the password jumper plug in the "disabled" position. However, before you assign a new system and/or setup password, you must return the jumper plug to the enabled position. NOTE: If you assign a new system and/or setup password with the jumper plug still in the "disabled" position, the system disables the new password(s) the next time it boots. 6 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 7 Open the system. See "Opening the System" on page 60. 8 Move the password jumper back to the enabled position to restore the password function. See Table 6-1. 9 Close the system. See "Closing the System" on page 61. 10 Reconnect your system and peripherals to their electrical outlets, and turn on the system. 11 Assign a new system and/or setup password. To assign a new password using the System Setup program, see "System and Setup Password Features" on page 51. Jumpers and Connectors 147