Dell Dimension 4600 Owner's Manual - Page 72
Remove two extra alignment screws, shown in the illustration on from the front
View all Dell Dimension 4600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
www.dell.com | support.dell.com 7 Pull the two front-panel tabs towards you, and then push out the front-panel insert. tabs (2) insert 8 Ensure that the jumper setting on the new drive is set for "cable select" (see the documentation that came with the drive for information). 9 Remove two extra alignment screws, shown in the illustration on page 72, from the front of the computer and insert them into the drive. drive alignment screws (2) NOTE: Some computers come with only two extra alignment screws; others come with four. You only need two alignment screws for this procedure. 10 Gently slide the drive into place. 72 Adding Parts
72
Adding Parts
www.dell.com | support.dell.com
7
Pull the two front-panel tabs towards you, and then push out the front-panel insert.
8
Ensure that the jumper setting on the new drive is set for "cable select" (see the
documentation that came with the drive for information).
9
Remove two extra alignment screws, shown in the illustration on page 72, from the front of
the computer and insert them into the drive.
NOTE:
Some computers come with only two extra alignment screws; others come with four. You only
need two alignment screws for this procedure.
10
Gently slide the drive into place.
tabs (2)
insert
drive
alignment screws (2)