Dell Force10 C300 Installing and Maintaining the C150 System - Page 20

CAUTION, Closing the Levers, Pressing the Knurled of the Lever

Get Dell Force10 C300 PDF manuals and user guides View all Dell Force10 C300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

www.dell.com | support.dell.com Step 5 Task Rotate the levers toward the card to seat the backplane connectors and line card in place. Push on the knurled section of the levers until the thumb tabs pop up and lock the unit in place, as shown in Figure 5-3 and Figure 5-4. CAUTION: Installing a card without fully engaging the locking mechanism might damage the EMI seal on the card below it when that card is inserted. Figure 5-3. Closing the Levers Figure 5-4. Pressing the Knurled Section of the Lever 6 Install a blank panel in all slots that do not have a card, and secure it with the screws provided. NOTE: The blank panels for RPMs and line cards are different sizes (RPM blanks are smaller); be sure that blank panels are installed in the correct slots. 20 | RPMs and Line Cards

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
20
|
RPMs and Line Cards
www.dell.com | support.dell.com
5
Rotate the levers toward the card to seat the backplane connectors and line card in place. Push on the knurled
section of the levers until the thumb tabs pop up and lock the unit in place, as shown in
Figure
5-
3
and
Figure
5-
4.
CAUTION:
Installing a card without fully engaging the locking mechanism might damage the EMI seal on
the card below it when that card is inserted.
Figure 5-3.
Closing the Levers
Figure 5-4.
Pressing the Knurled Section of the Lever
6
Install a blank panel in all slots that do not have a card, and secure it with the screws provided.
NOTE:
The blank panels for RPMs and line cards are different sizes (RPM blanks are smaller); be sure that
blank panels are installed in the correct slots.
Step
Task