Dell Force10 C300 Installing and Maintaining the C150 System - Page 48

www.dell.com | support.dell.com Command Purpose (continued) interface management port config 100m • Use these commands to set the speed and duplex settings for the Management interface.The default setting is full-duplex and auto-negotiation. interface management port config 10m interface management port config auto-negotiate • Use the interface management port config show command to view the Management interface's physical settings. interface management port config no auto-negotiate interface management port config full-duplex interface management port config half-duplex interface management port config show show interface management ethernet • Use the show interface management ethernet command to display the IP address and network mask of the management Ethernet port. interface management ethernet ip address ip-address ip-addressmask • If the show command output does not display configured IP address information, use the interface management ethernet ip address ip-address ip-address-mask command to set the IP address of the Management Ethernet port for network (ftp/tftp) operating system boot. Use CIDR block notation for the subnet mask. BOOT_USER # show interface management ethernet No IP address set for interface management ethernet 0/0! BOOT_USER # interface management ethernet ip address 1.2.3.4/24 Management ethernet 0/0 IP address: 1.2.3.4/24 boot zero {default | primary | secondary} reload Delete the boot configuration. Reload software. The autoboot program initializes and displays self-test results on the console screen. NOTE: Do not press break control sequence at any time during the boot/ reboot process. Doing so causes the boot process to terminate. Refer to the FTOS Command Line Interface Reference for BOOT_USER mode commands and commands for run-time modes. 48 | System Boot