Dell Latitude CPt V Service Manual - Page 35

7. Fold the LCD flex cable at the crease shown in Figure 16, so the name of the LCD panel manufacturer faces up. The connectors on the Torisan and Sharp LCD panels are mounted in the reverse of each other. This means that pin 1 on the Torisan panel connector is at the opposite end when compared to pin 1 on the Sharp panel connector. Both panels have the same connector, but the connector is mounted differently. The LCD flex cable can connect to either panel by making one fold to the cable. The words Torisan and Sharp are printed on the cable (see Figure 16). If you are installing a Torisan LCD panel, fold the cable at the crease so the word Torisan is facing up. If you are installing a Sharp LCD panel, fold the cable at the crease so the word Sharp is facing up. Fold for a Sharp LCD Panel curled back to connect to panel LCD manufacturer name Fold for a Torisan LCD Panel crease (on top) crease (underneath) To replace the 12.1-inch display LCD panel inverter, perform the following steps: 1. Find the manufacturer's name on the back of the LCD panel that is to be installed. The manufacturer is either Torisan or Sharp. 2. Ensure that the inverter's configuration jumpers are set correctly (see Figure 17). If you are installing a Sharp LCD panel, both jumpers are used. If you are installing a Torisan LCD panel, the bottom jumper is used. See the sticker on the inverter shield for more information. support.dell.com Dell Latitude CPt V-Series/CPx H-Series Service Manual 27