Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 179

Default Command Mode Usage Information Example 32 INTERFACE The no version of this command resets the maximum bundle size to the default value. OS10(conf-if-po-10)# lacp max-bundle 10 Supported Releases 10.2.0E or later lacp port-priority Sets the priority for the physical interfaces for LACP. Syntax Parameters Default Command Mode Usage Information Example lacp port-priority priority priority - Enter the priority for the physical interfaces (0 to 65535). 32768 INTERFACE LACP uses the port priority with the port number to create the port identifier. The port priority decides which ports are put into Standby mode when there is a hardware limitation that prevents all compatible ports from aggregating, or when you have more than eight ports configured for the channel group. When setting the priority, a higher number means a lower priority. The no version of this command returns the port priority to the default value. OS10(conf-range-eth1/1/7-1/1/8)# lacp port-priority 32768 Supported Releases 10.2.0E or later lacp rate Sets the rate at which LACP sends control packets. Syntax lacp rate {fast | normal} Parameters • fast - Enter the fast rate of 1 second. • normal - Enter the default rate of 30 seconds. Default Command Mode Usage Information Example 30 seconds INTERFACE Change the LACP timer rate to modify the duration of the LACP timeout. The no version of this command resets the rate to the default value. OS10(conf-range-eth1/1/7-1/1/8)# lacp rate fast Supported Releases 10.2.0E or later Layer 2 179