Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 27

3 Ping the remote server from the switch - use the ping and traceroute commands to test network connectivity. If the ping fails: • Check if a Management route is configured on the switch. If not, use the management route command to configure a route to the server network. • Install the server with the license file on the same subnet as switch. 4 Check if the server is up and running. Remote access You can remotely access the OS10 command-line interface (CLI) and the Linux shell. When you install OS10 the first time, connect to the switch using the serial port. Configure remote access • Configure the Management port IP address • Configure a default route to the Management port • Configure a user name and password Remote access OS10 CLI 1 Open an SSH session using the IP address of the device. You can also use PuTTY or a similar tool to access the device remotely. ssh admin@ip-address password: admin 2 Enter admin for both the default user name and password to log into OS10. You are automatically placed in EXEC mode. OS10# Remote access Linux shell ssh linuxadmin@ip-address password: linuxadmin Configure Management IP address To remotely access OS10, assign an IP address to the management port. The management interface is used for out-of-band (OOB) management purposes. 1 Configure the management interface from CONFIGURATION mode. interface mgmt 1/1/1 2 By default, DHCP client is enabled on the Management interface. Disable the DHCP client operations in INTERFACE mode. no ip address dhcp 3 Configure an IPv4 or IPv6 address on the Management interface in INTERFACE mode. ip address A.B.C.D/mask ipv6 address A:B/prefix-length 4 Enable the Management interface in INTERFACE mode. no shutdown Configure Management interface OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# no ip address dhcp OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24 OS10(conf-if-ma-1/1/1)# no shutdown Getting Started 27